SBS-3 Interface Connection

This forum contains frequently asked questions and their answers. (Note: This forum is read-only).

Moderators: admin, KineticChris, KineticDavid, Moderators

User avatar
KineticDavid
Site Admin
Posts: 91
Joined: May 20th, 2005, 10:45 am
Location: London

SBS-3 Interface Connection

Postby KineticDavid » January 2nd, 2013, 3:10 pm

In answer to a request for the pin out of the RJ11 interface connector on the rear of the SBS-3
Pin 1 is the rightmost pin as viewed from the rear of the SBS-3

Pin 1 : 5VDC. (Pull up resistors only. Not to be used for powering any external equipment. )

Pin 2 : I2C Clock (Used by Kinetic for external module options)
Pin 3 : I2C Data (Used by Kinetic for external module options)

Pin 4 : RS232 Tx (Used to control external Radio receivers)
Pin 5 : RS232 Rx (Used to obtain GPS co-ordinates for BaseStation when selected)

Pin 6 : RS232 & I2C Ground

----------------------------------------------------------------------------------

I hope this helps.

Please note that we re-enabled the external Radio Interface control panel within BaseStation V179

Regards

David

Return to “FAQ”

Who is online

Users browsing this forum: No registered users and 2 guests